Manitoba Motorcycle Test 02

Our Manitoba Motorcycle Practice Test covers all the essential topics that are included in the actual MPI written exam. These include traffic laws, road signs and signals, safe riding techniques, handling hazardous conditions, and more.

/30

Manitoba Motorcycle Practice Test 02

1 / 30

Which statement is FALSE? Check wheels and rims for the following...?

Broken or loose spokes

The bearings or bushings for damages or wear

Cracked or damaged castings

Scuffs on the side of the rim

2 / 30

Which statement is FALSE? The following are procedures needed each time before you start your engine...?

Move the motorcycle off its stand and be sure the stand is secure in its upright position

Mount the motorcycle from the left side, holding both handle grips firmly. Keep the motorcycle upright with both feet on the ground for support

Make note of the motorcycle safety check to do later

Put on all your safety equipment

3 / 30

Electric starters are usually located...?

On the right handlebar

On the left footrest

On the left handlebar

On the right footrest

4 / 30

Which statement is FALSE? Before you ride you should...?

Have good balance and control of your vehicle at least half of the time

Know the position of all your controls and how to use them properly

Be able to start and stop in a controlled manner

Be able to use your clutch and change gears smoothly

5 / 30

Is it illegal to alter the neck angle of the front frame of a motorcycle?

Yes

Not on motorcycles below 250cc

Not on motorcycles above 250cc

6 / 30

Which statement is FALSE? When you are on the motorcycle, you should feel comfortable and in control by doing the following...?

Hold the throttle with your wrist lowered, so you can easily reach the brake with your fingers

Sit in a position where your elbows are straight when your hands are on the handlebars. Keep your back straight and lean slightly forward to reduce wind resistance.

Maintain slight pressure on the fuel tank with your knees

When moving, your feet should be level and firmly on the footpegs and ready to use the foot controls at all times

7 / 30

When seated on the motorcycle, there should be how much play at the centre of the chain?

At least three cm

At least one cm

At least two cm

At least four cm

8 / 30

Which statement is FALSE? Before you ride in traffic or on a highway, you should...?

Be able to use your clutch and change gears smoothly

Be able to have good balance and control of your vehicle most of the time

Know the position of all your controls and how to use them properly

Be able to start and stop in a controlled manner

9 / 30

When starting on hills, what can be done to hold the motorcycle from rolling back?

Use the front brakes to hold it in place

Keep the motorcycle on the stand

Start the motorcycle while standing to the left side of it

All of these

10 / 30

The brakes on the front and rear wheel, capable of stopping the motorcycle on a dry, smooth, level road within nine metres from a speed of...?

40 km/h

25 km/h

50 km/h

30 km/h

11 / 30

A dimmer light switch is generally located...?

On the right footrest

On the left footrest

On the right handlebar

On the left handlebar

12 / 30

What's the height the handlebars may not above the seat while the rider is sitting on the motorcycle?

28cm

42cm

46cm

39cm

13 / 30

How do you compensate for vehicles behind you that cannot stop as quickly as you can?

Avoid braking

Use your horn before braking

Braking earlier and gradually

All of these

14 / 30

At what speed should you disengage the clutch and shift to first gear prior to stopping?

Once you stop

When speed drops below 10 km/h

When speed drops below 20 km/h

When speeds get to roughly 5 km/h

15 / 30

The front forks should not be longer than how much as measured from the bottom of the lower triple tree to the centre of the axle?

76cm

92cm

68cm

82cm

16 / 30

Check the pressure when the tires are...?

Cold

None of these

Hot after a long ride

Worn

17 / 30

Starting and stopping are two of the most common areas where beginner motorcycle operators...?

Lose control

None of these

Excel quickly

Pause

18 / 30

The horn must be audible, under normal conditions, from a distance of...?

40m

90m

60m

80m

19 / 30

Check each fastener for...?

Tightness

Correct size

All of these

Rust

20 / 30

Why should you never ride with the brake partly applied?

It turns on your brake light, which confuses other drivers

All of these

It may cause your brakes to lock

It cancels out the other brakes

21 / 30

What are the dimensions of the handlebars?

Not more than 82 cm and not less than 43 cm wide

Not more than 78 cm and not less than 51 cm wide

Not more than 96 cm and not less than 63 cm wide

Not more than 92 cm and not less than 53 cm wide

22 / 30

Which statement is FALSE? Special caution should be taken when braking under the following conditions...?

Slippery or rough road surface

Having a passenger

Turned front wheel

Leaning into a turn

23 / 30

If you are in a line of traffic, what can you do to alert those behind you before you apply your brakes steadily?

Wave your left hand upwards

Wave your left hand downwards

Nothing

First flash your brake lights

24 / 30

The throttle should do what when released?

Remain in the same position

None of these

Push forward

Spring closed

25 / 30

Motorcycle tires must have at least how much tread?

.8mm

.6mm

1.5mm

1.3mm

26 / 30

Should you always downshift when slowing down or when preparing to stop?

Only on slippery conditions

Only while traveling downhill

Yes

27 / 30

How much of the braking force is done with the front brakes?

30%

90%

50%

70%

28 / 30

What is the purpose of the choke?

Adjusts the mixture of air and gas and is usually used on a hot day

Adjusts the mixture of air and gas and is usually used to start a cold engine

Adjusts the mixture of air and gas and is usually used on a cold day

None of these

29 / 30

The fenders on the front and rear wheels, which effectively reduces what?

Air drag and resistance

The wheel spray or splash of water from the roadway

The aerodynamics

All of these

30 / 30

A controlled stop in wet or dry conditions requires what to happen?

The front brake be applied until slow, then the rear brake applied

The rear brake be applied first to avoid a loss of steering

Both front and rear brakes be applied at the same time without locking them

Downshift first to drop the speed significantly

Your score is